Seat belt installation checks

Approved advisories in this category.

Showing 1 to 24 of 30 advisories in Seat belt installation checks.

• Offside rear seat belt with load spreading washer(s) missing from anchorage bolt

  Reference 10.2 (n)

• Offside front seat belt with load spreading washer(s) missing from anchorage bolt

  Reference 10.2 (n)

• Nearside rear seat belt with load spreading washer(s) missing from anchorage bolt

  Reference 10.2 (n)

• Nearside front seat belt with load spreading washer(s) missing from anchorage bolt

  Reference 10.2 (n)

• Seat belt with load spreading washer(s) missing from anchorage bolt

  Reference 10.2 (n)

• Seat belt anchorage attached to the floor without reinforcement plates of a suitable size and contour (see notes N and O)

  Reference 10.2 (m)

• Quick release seats in such a position that loading the belt causes the cushion to be raised or significantly compressed thus allowing the occupant effectively to move forward

  Reference 10.2 (l)

• Rail or other harsh object without suitable padding as required at note M

  Reference 10.2 (j)

• Offside rear seat belt anchorage insecure

  Reference 10.2 (d)

• Offside front seat belt anchorage insecure

  Reference 10.2 (d)

• Nearside rear seat belt anchorage insecure

  Reference 10.2 (d)

• Nearside front seat belt anchorage insecure

  Reference 10.2 (d)

• Seat belt anchorage insecure

  Reference 10.2 (d)

• A directly attached seat belt anchorage not secured by standard seat belt mounting bolts and washers as detailed in note D

  Reference 10.2 (c)

• Part of the seat belt installation has a sharp edge which could or is likely to cut or abrade the webbing

  Reference 10.2 (b)

• Evidence that original seat belt webbing has been cut and/or reworked; eg belts knotted, fraying or fluffing removed/ sealed by burning etc (see note A)

  Reference 10.2 (a)

• A seat belt component fitted to a seat significantly intrudes into a gangway and is likely to cause injury to a passenger

  Reference 10.2 (v)

• Incorrect positioning of a lap belt or lap section of a three point belt, ie the belt lies across the stomach or forward of the top quarter of the thigh

  Reference 10.2 (u)

• Upper anchorage of three point belt(s) less than 110mm from centre line of seat (see note T)

  Reference 10.2 (t)

• Upper anchorage of three point belt less than 475mm above uncompressed seat cushion measured parallel to the seat back (see note T)

  Reference 10.2 (s)

• Free movement for a looped belt more than 25mm at the anchorage

  Reference 10.2 (r)

• Tracking for seats and wheelchairs insecure (see note R)

  Reference 10.2 (q)

• On a seat fitted to a flat rail the bolt does not pass through the leg, rail, floor, and a suitable structural member, or the floor has not been suitably reinforced

  Reference 10.2 (p)

• Claw type seat mounting with inadequate means of securing claw (see note P)

  Reference 10.2 (o)